GM 1 Ton Reamer 7.15 degree (1.5 inch per ft)

One ton tie rod ends are a great upgrade but usually your pitman arm or knuckles will have to be reamed to accept the larger taper that these tie rod ends require. This reamer will allow you to make the proper 7.15° or 1.5" per ft taper in your steering components. This is also the reamer that you need to make a deeper taper for the GM high angle tie rod ends (ES2026, ES2027). This reamer has 3 flats machined in the shank for use in a drill chuck. .812 inch max diameter .530 inch minimum diameter Some notes on using a reamer: This reamer is manufactured from high speed steel, this is a very hard material. This allows the tool to maintain a good cutting edge if used properly, however high speed steel is also very brittle. Any cutting tool is susceptible to heat and chatter, either one will ruin your reamer in short order. We recommend a maximum of 100 RPM, large amounts of quality cutting oil, and it is extremely important to keep the reamer straight and centered in the hole you are reaming. Never run your reamer backwards (counter clockwise) this will dull the cutting edges. If you follow the above guidelines, your reamer will give you years of service.

ASIN

B01MXHMF4Q

Embedding

CLIP ViT-L/14 · 768d

Distance metric

cosine

Doc fetch

6ms·cache hitGET /v2/namespaces/amazon-products/documents/B01MXHMF4Q

Similar query

49msre-embed title → /query

Doc fetch goes through Layer's Aerospike pull-through cache; cache hit served the row without touching turbopuffer. The similar query re-embeds this product's title with CLIP-text and runs a vector query — queries don't go through the doc cache, so no cache header is set.